Product Code: K-VABI001A-AP-SUN

Availability:In stock

  • Zero Voltage Drop.Won't rob precious power from your batteries and electrical system, unlike heat sinking competitors.
  • Small Convenient Size.Only about 2 inches tall, wide & deep the isolater fits just about anywhere!
  • Fast & Easy Installation. Simple power wire IN, power wire OUT install. Comes with mounting plate/template.
  • IP65 Weather & Strong Vibration Protection. Suitable for all off-road vehicles and weather exposed applications.
  • Most Efficient Programming in the Business. Ensures your electrical system functions properly and batteries charge accurately.
  • Specially designed for ATV, UTV, boats, RV's, campers, 5th wheels, off road vehicles, Rhino, Polaris, Artic, Cat, Etc.
  • Comes With Necessary Hardware & Mounting Instructions.


Forget the traditional diode relays and so-called "solid state" devices that can rob you of almost 2 amps of output voltage! The ATEM POWER Dual Battery Isolator is the only SMART unit designed with cutting edge programming to deliver optimum performance - with ZERO sacrifice. This compact battery isolator was built ultra-small (1" x 1" x 3") to fit almost anywhere! A perfect fit under the hood to get close to your dual batteries.When the engine is started, the starting and auxiliary batteries are separated allowing only the starting battery to be charged. When the charge voltage reaches 13.3 volts the VSR engages allowing both starting and auxiliary batteries to be charged. This is indicated by the red light in the top LH corner being illuminated. When the engine is stopped and the battery voltage falls below 12.8 volts the VSR disengages separating the start and auxiliary batteries. The auxiliary battery continues to power any accessories without risk of draining the starting battery.This VSR is "Dual Sensing" which senses the voltage of both batteries.This is very useful in that being Dual Sensing (bi directional), you have a battery charger or solar power connected to your auxiliary battery and this battery gets charged enough to the VSR's set points , the VSR then will allow your charging source to back charge the cranking battery as well bringing that to fully charged as well but again, if the voltage drops below 12.8 volts, the VSR will again disconnect (isolate) the batteries.Unlike other chargers on the market today, the ATEM POWER Automatic 140 Amp Dual Battery Isolator is IP65 Certified. This International Protection rating means that your ATEM POWER charger is safe for use even for your off-road needs in dusty, wet and unexpected extreme weather environments.


Continuous Current 140A

Max Current 160A

Current Draw - Charging 280mA

Current Draw - Standby 8mA

Disengage delay 5-10 Seconds

Recommended Fuse 80Amp

Power Studs M6 Stainless Steel

Surge ProtectionBuilt-in


Weight 300g


1 Year Warranty


  • 1x 12V Voltage Sensitive Relay
  • 1x 7AWG X 24" Red Battery Cable Cut to Length (W/Single Connection)
  • 1x 7AWG X 12“ Length Red Battery Cable (W/Two Connectors)
  • 1x 12" Length Battery to Ground Cable (W/Two Connectors)
  • 1x 5/16” Lug Cable End
  • 2x 3/8” Lug Cable End
  • 2x Red Shrink Tube
  • 2x Hook and loop Velcro
  • 1x Accessories